Search
Filters
Close

1.25" x 2.6" MPWH Locking Strip - 2 Pack

$5.00 Case Cost
($2.50 per unit - 2 units)

1.25” x 2.6” Locking Strip

1.25” x 2.6” Locking Strip is a replacement part for the factory installed Locking Strip on the MPWH.   Locking Strip will remain strong for up to 1000 closure cycles depending on conditions and usage. If you notice visible damage or a reduction in holding strength, replace the Locking Strip on your MPWH.

1.25” x 2.6” Locking Strip

1.25” x 2.6” Locking Strip is a replacement part for the factory installed Locking Strip on the MPWH.   Locking Strip will remain strong for up to 1000 closure cycles depending on conditions and usage. If you notice visible damage or a reduction in holding strength, replace the Locking Strip on your MPWH.

Specs: 1.25" x 2.6" MPWH Locking Strip

For Use With:
Multi-Purpose Weaponholder (MPWH)
Color: Black
Dimensions: 1.25" W x 2.6" L
Weight: With Liner - 3.4 G. Without Liner 3.2
Material: Stem/Heads/Backing - Polypropylene
Adhesive: Clear Acrylic
Liner: Red
Closure Life Cycle: 1000
Thickness: 0.14" (3.5 mm)
Engaged Thickness: 0.23" (5.7 mm) ± 15%
High Temperature Range: 220°F

1.25” x 2.6” Locking Strip

Q: Should I ever replace the Locking Strip on my Weaponholder?

A: Yes.  Repeated use will cause your Locking Strip to wear.  If the Locking Strip on your MPWH appears damaged or worn, replace it.  Even if there’s no visible sign of wearing and the holding strength seems to be weakening, replace the locking strip. This is a quick and easy step to insure your system maintains its peak performance.

Q: Do I need to use a Prep Wipe before applying the Locking Strip.

A: Yes. When replacing Locking Strip on the MPWH, remove any adhesive residue left by the previous Strip. A clean surface is necessary for proper installation of a new Locking Strip.

Q: Do I need to use a Primer Stick.

A: Yes.  If you plan to use your system within 72 hours you should use a Primer Stick. Using a Primer Stick will allow the adhesive on the Locking Strip to achieve its maximum cure strength in 1 hour versus 72 hours without the Primer.  Use of the Weaponholder before the adhesive has cured will most likely result in a weaker mount and may cause the Locking Strip to come off or have a weakened attachment to the MPWH. 

Q: How do I clean my Locking Strip?

A: The two easiest and most effective methods are blowing compressed air or running water. This should help to loosen and remove dirt and debris.  Be careful when cleaning your Locking Strip not to damage the stems.  In the event you are unable to remove materials that are causing problems, remove and replace the Locking Strip.